הצהרת נגישות
© כל הזכויות שמורות 2018
The one of a kind silicone thickness and distribution analyzer.
Keep your silicone in check
Wonky silicone coatings for injectable devices can jam them up or ooze oil into your drug. Bouncer makes it easy to find out if the coating’s too thick, too thin or good to go. Its quantitative measurements on silicone layer thickness and distribution let you find the sweet spot for your device.
Thickness
Distribution
Mass
Bring in the muscle
Doesn’t matter if you bake it or spray it, Bouncer knocks out silicone thickness and distribution measurements on syringes, cartridges and vials in just a few minutes. Put your device on the stage and Bouncer eyes it up, down, and all around.
Get the lowdown
Bouncer uses basic white light reflectometry to measure sprayed-on coatings down to 80 nm. Switch to laser interferometry for baked-on glass coatings as thin as 20 nm. Either way, you’ll get the blow-by-blow on your device.
Find your VIPs
To make sure you’ve got a consistent layer of silicone, Bouncer scopes out the entire inside surface of your device. We’re talking tons of data points in full 360°. You get a 2D and 3D map that shows you where you’ve got too much, too little or just enough.
Ditch the rejects
Too little silicone and your plunger gets stuck. Too much and it’s free to float around and make your protein aggregate. Bouncer gives you the thickness and distribution data needed to figure out which coatings work and which should get the boot.
For more information about Bouncer – silicone thickness and distribution analyzer
